[Return to main site] 

Piece NOT parallel to the bed


#1

After a couple of impressions … I’ve gone back to the problems.

This time is that the piece is not parallel to the BED or PLATFORM.

I’m almost sure, that’s what I did, which was to change the FET VAT and adjust the 0 point … as, loosening the screws laterlales, doing a Home and returning them to tighten …

But something I have overlooked, since the print fails, is printed approximately 1 cm, and what you get to print looks as if the print is turned … as if the platform is not paralera to VAT …

Then I will attach photos, it was in case you had any ide of what could happen