[Return to main site] 

Print part Z-axis is larger than the model design


#1

I started new with Titan 2. Kudo calibration print came very well. After that I tried to print one part after slicing in CW. However the print appear like dragged Z-axis as you can see in the attachment figure. Please correct me where am I doing wrong?


#2

at the time of slicing in CW you may have kept slice height less than you are using slice height while running the print.


#3

Hi GCT,

Thank you for your reply. Yes the CW settings of slice thickness is 0.02mm, while in the settings of Kudo3D printing setting slice thickness was 0.05mm.

I am now re-doing the print by keeping these two numbers same.